Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Audi Cabriolet 2.8 AFACTORY OEM SERVICE PROCEDURE
Quick Lookups: Fluids
| FLUID CAPACITIES | |||||||
|---|---|---|---|---|---|---|---|
| Fluid Type | Application | Standard | Metric | Fluid Spec | Note | S/H | |
| Air Cond Compressor Oil | 8.50 OZS. | 0.25 L | PAG 46 | S | |||
| Air Cond Refrigerant | 1.50 LBS. | 0.68 KG | R-134a | S | |||
| Automatic Transmission Fluid | 5.70 QTS. | 5.39 L | Automatic Transmission Fluid DEXRON or DEXRON II for torque converter. Synthetic Transmission Fluid G50, SAE 75W-90 for final drive | S | |||
| Brake Fluid | N/A | N/A | DOT 4 Brake Fluid | Fill between "max" and "min" lines on reservoir. | S | ||
| Engine Coolant | 2.90 GALS. | 10.97 L | 50/50 mixture of Ethylene Glycol Antifreeze and water | Use Phosphate-free Antifreeze. | S | ||
| Engine Oil | 5.30 QTS. | 5.01 L | API - SAE 5W-30 (Below -0Deg.F to 80Deg.F), 10W-30/40 (5Deg.F to 80Deg.F), 15W-40/50 (5Deg.F to Above 100Deg.F), 20W-40/50 (15Deg.F to Above 120Deg.F) | S | |||
| Fuel Tank | 18.00 GALS. | 68.13 L | Reserve tank capacity: 2.1 gals. | S | |||
| Windshield Washer Fluid | w/Windshield & Headlight Container | 6.70 QTS. | 6.34 L | Mixture of water and a Glass Cleaning Solution | Follow the Manufacturer's Instructions for the mixture ratio. | S | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.