Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Audi S4FACTORY OEM SERVICE PROCEDURE
Engine Controls - System & Component Testing: Introduction
WARNING:
DO NOT touch or disconnect ignition system wires when the engine is running or being cranked at starting RPM. DO NOT operate the starter if the fuel injectors have been removed. Be sure the ignition is switched OFF, when disconnecting ignition wires, disconnecting fuel injection system wiring, connecting or disconnecting test equipment leads disconnecting the battery or washing the engine compartment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.