Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Notes
Removal & Installation: ECM: Notes — 1994 Audi S4 Service Manual & Installation >> ECM >> Notes Removal & Installation: ECM: Notes CAUTION: DO NOT have the (VAG 1551) Scan Tool connected at the same time as the (VAG 1598) test box. BEFORE disconnecting the ECM harness connector, switch the ignition OFF and WAIT at least 30 seconds. Failure to do so may damage the ECM. By disconnecting the Motronic ECM harness connector, the battery positive voltage supply to the permanent memory is also disconnected, which in turn erases the DTC memory.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.