1994 Audi S4FACTORY OEM SERVICE PROCEDURE

Display Group 01-09

NOTE: For help in identifying Display Group Number Breakdown and Display Group Number Overview information charts (tables), refer to illustrations. See Figure -Figure
  1. Press the -C- button each time a new display group is required.
  2. If the -right arrow- button is pushed or the -C- button is accidentally pressed twice, "Read Measuring Value Block" function 08 must be re-selected.
  3. Clarification and additional information for individual displays or data (for the specified values) can be found in SYSTEM & COMPONENT TESTING article.
  4. The displays described in display groups 01 to 05 and display group 07 are not all used.
  5. Display group 01 selection has been shown as an example. Select the other display groups in the same way.
  6. Press buttons -0- and -1- to select display group 01. Display will read - "READ MEASURING VALUE BLOCK" "INSERT DISPLAY GROUP NUMBER 01".
  7. Press -Q- button to confirm input. Display will read - "READ MEASURING VALUE BLOCK" "1 2 3 4".
    NOTE: When display groups 00 through 09 are displayed with "Read measuring value block," the zeroes in the display group designations are omitted from the display. Display group 00 is not shown. Display groups 01 through 09 are shown as single numbers 1, 2, 3, etc.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.