Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Audi S4FACTORY OEM SERVICE PROCEDURE
Display Group 00
NOTE:
For help in identifying Display Group Number Breakdown and Display Group Number Overview information charts (tables), refer to illustrations. See Figure
-Figure
- Select desired display group number corresponding to the display group overview.
- Press -Q- button to confirm input. "DISPLAY GROUP 00". Press -0- button twice to select display group 00.
- Display will read - "READ MEASURING VALUE BLOCK" "INSERT DISPLAY GROUP NUMBER 00".
- Press -Q- button to confirm input. Display will read - "READ MEASURING VALUE BLOCK" "1 2 3 4 5 6 7 8 9 10".NOTE: With printer connected, each time the PRINT button is pressed the most recent display will be printed. Press -C- button before selecting additional display groups. After selecting another display group, printer must be switched on again each time.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.