Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Audi S4FACTORY OEM SERVICE PROCEDURE
Idle Speed: Testing
NOTE:
DO NOT take measurements while radiator cooling fan is operating.
- Start engine and let idle.
- Select engine Basic Setting. See BASIC SETTING FUNCTION (4) in SELF-DIAGNOSTICS .
- Value in display channel 1 (display field, RPM) must be within 770-830 range.
- If NO: Perform the following steps:
- Read DTC Memory again.
- Initiate Output Diagnostic Test Mode (DTM). See OUTPUT DIAGNOSTIC TEST MODE in SELF-DIAGNOSTICS .
- Check test table for possible cause of malfunction. See BASIC SETTING VALUES CHECKING TABLES under OUTPUT DIAGNOSTIC TEST MODE in SELF-DIAGNOSTICS .
- Make the necessary repairs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.