Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Audi S4 2.2 PFACTORY OEM SERVICE PROCEDURE
Throttle Angle Output Signal Checking: Testing
- Connect (VAG 1598) test box, using (VAG 1598/5) adapter cable to ECM. See CONNECTING VAG 1598 TEST BOXΒ .
- Connect (US 1115) LED tester between ground terminal No. 19, and terminal No. 54.
- Start engine and let idle. LED tester must light up dimly.
- Apply accelerator pedal. LED tester light must become brighter.
- If LED tester does NOT light up or is NOT brighter when applying accelerator pedal. Check for malfunctioning Throttle Position (TP) sensor. See THROTTLE POSITION SENSORΒ .
- If TP sensor Okay: Replace ECM. After replacement of ECM, see ECM IDENTIFICATION and ECM CODING under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS article.
- If LED tester lights up and is brighter (when applying accelerator pedal): Check for short to ground between ECM terminal No. 54 and Transmission Control Module (TCM). See WIRING DIAGRAMSΒ .
- Check for malfunction in TCM - constant short to ground.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
