Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Audi S4 2.2 PFACTORY OEM SERVICE PROCEDURE
Checking Control Function
- Select "READING MEASURING VALUE BLOCK" function 08 on (VAG 1551) Scan Tool and input display group 01. See CONNECTING SCAN TOOL (VAG 1551)Β .
- Observe display value in channel 3. Display must be: 0.96-1.04 volts.
- Display must not remain at 1.0 volts (average value): value must fluctuate. If specified value is NOT obtained, check for the following malfunctions:
- Fuel system pressure too high or too low. See FUEL PRESSURE under FUEL SYSTEM in BASIC DIAGNOSTIC PROCEDURES article.
- Leak in intake air system between engine and Mass Air Flow (MAF) sensor. Inspect for vacuum leaks.
- Leak in exhaust system between engine and HO2S probe. Inspect for exhaust leaks.
NOTE:
A display value OVER 1.04 indicates that the HO2S has detected a lean condition and, to compensate, has enriched the control system. A display value UNDER 0.96 indicates that the HO2S sensor has detected enrichment and to compensate, has created a lean condition.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
