Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Audi 80 Base, 2.3 C, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pump Relay Control
- With ignition off, remove fuel pump relay from fuse/relay panel. Connect voltmeter between relay terminals No. 48 and 50. See Fig 1 . Voltmeter should indicate battery voltage.
- Repair circuit if reading is not as specified. Connect voltmeter between relay terminals No. 46 and 50. Turn ignition on. Voltmeter should indicate battery voltage.
- If reading is not as specified, repair break in wiring. Connect voltmeter between relay terminals No. 46 and 47. Momentarily engage starter and note reading on voltmeter. Reading should be 7 volts.
- If reading is not 7 volts, remove ICU harness connector. Using an ohmmeter, measure resistance between ICU terminal No. 3 and relay terminal No. 49 and between ICU terminal No. 14 and relay terminal No. 47.
- Readings should be less than .2 ohm. If readings are not as specified, repair open in circuit(s). If readings are as specified, replace knock sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
