Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Control Unit
The Electronic Control Unit (ECU) is used on CIS Digital Control systems. CIS-E III system uses the following 2 interfacing computers: Ignition Control Unit (ICU) and Fuel Injection Control Unit (FICU). If CIS-E III system has a knock sensor, the control unit is referred to as a Knock Sensor Control Unit (KSCU).
The control unit receives signals from air sensor potentiometer, oxygen sensor, coolant temperature sensor, throttle valve switches, oxygen sensor and other sensors specific to the individual system. The control unit uses data from these sensors to vary air fuel mixture and ignition timing to maintain optimum performance, fuel economy and emission standards.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
