1990 Audi 80 QuattroFACTORY OEM SERVICE PROCEDURE

Cold Acceleration Enrichment

  1. Disconnect differential pressure regulator harness connector. See Figure for differential pressure regulator harness connector location. Using Adapter (VW 1315 A/1), connect Multimeter (US 1119) to differential pressure regulator and harness connector. See Figure .
  2. Set multimeter to 200 mA DC scale. Disconnect oxygen sensor connector. Start engine and let idle. Note multimeter reading. Accelerate engine. Multimeter reading should increase approximately 6 mA during acceleration.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.