Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Audi 200 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
O2 Sensor Heating Element
- To check O2 sensor heating element, disconnect O2 sensor heating element connector from harness connector. Connect voltmeter between harness connector terminals No. 1 and 2. See Fig 1 .
- Turn ignition on. Voltmeter should read 12 volts. If voltmeter does not read as specified, repair break in wiring. Connect ohmmeter between terminals No. 1 and 2 of O2 sensor heating element connector. See Fig 2 .
- Ohmmeter should read 3-15 ohms. If not, replace O2 sensor.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.