1990 Audi 100 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Differential Pressure Regulator Fuel Pressure

  1. Connect Fuel Pressure Tester (VW 1318) as previously described in FUEL SYSTEM PRESSURE. See Figure . Close fuel pressure valve. Relieve pressure. Disconnect harness connector at differential pressure regulator. Using Remote Control (US 4480/3), as previously connected in step 2) of FUEL SYSTEM PRESSURE, energize fuel pump and note fuel pressure. Fuel pressure should be 4.3-7.3 psi. (.3-.5 kg.cm2 ) less than fuel pressure noted in step 3) of FUEL SYSTEM PRESSURE.
  2. If not, remove small diameter fuel line from fuel pressure regulator and place in container. Plug fuel line opening on fuel pressure regulator.
  3. Using remote control, energize fuel pump for one minute and measure quantity of fuel in container. Fuel captured in container should be 130-150 ccs. If fuel quantity is less, replace fuel pressure regulator. Reconnect fuel line to fuel pressure regulator.
  4. Disconnect ignition coil wire and ground. Disconnect CTS harness connector and insert 15,000-ohm side of Bridge Adapter (VW 1490) into CTS harness connector. See Figure .
  5. Crank engine for about 5 seconds and leave ignition on. Using remote control, energize fuel pump and note reading on fuel pressure gauge. Fuel pressure must be 18.9-23.2 psi (1.4-1.6 kg/cm2 ) less than fuel pressure noted in step 3) of FUEL SYSTEM PRESSURE.
  6. If not, replace differential pressure regulator. If difference between fuel pressures is as specified, check wiring harness and ECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.