1990 Audi 100 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Low Boost Pressure

  1. Check air cleaner element for contamination or clogging. Clean or replace as necessary. If turbine or compressor wheels do not rotate smoothly and lightly when turned by hand, replace turbocharger assembly. Check for open wastegate valve or relief valve.
  2. If turbocharger appears to be in good condition but has low boost pressure, check for the following:
    • Gas leaks in exhaust system.
    • Increased exhaust resistance due to clogged exhaust pipe or muffler.
    • Air leaks from compressor discharge side.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.