Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Audi 90 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Cold Crank Enrichment
- Connect Dwell Meter (VW 1367) to vehicle. Using Adapter Cable (US 1112) connect Green test lead to OXS system test connector (Blue/Black wire). Set "%" button on duty meter.
- Ensure engine is below 68°F (20°C). Unplug and ground high tension spark lead at coil. Crank engine and check that duty cycle is a constant 80%. If not, check coolant sensor. If sensor is okay replace ECU.
- If duty cycle reading is okay, but cold start problems are present, check cold start valve and idle stabilization system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.