1988 Audi 80 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

WHEEL ALIGNMENT SPECIFICATIONS

Application Specification
Front
Camber in Degrees
Fraction -3/4 +/- 1/2
Decimal .50 +/- .31
Toe-In in Inches
Fraction 5/64 +/- 5/64
Decimal .08 +/- .08
Toe-In in Degrees
Fraction 5/32 +/- 5/32
Decimal .16 +/- .16
Rear
Camber in Degrees
Fraction -1 +/- 21/64
Decimal -1 +/- .33
Toe-In in Inches
Fraction 11/64 +/- 11/64
Decimal .17 +/- .17
Toe-In in Degrees
Fraction 11/32 +/- 11/32
Decimal .34 +/-.34
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.