Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1988 Audi 80 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Testing Precautions
When testing CIS Motronic system, observe following precautions to avoid injury or damage to the system.
- DO NOTÂ touch or disconnect ignition wires with engine running. Disconnect or connect engine wiring and test leads ONLY with ignition off. DO NOTÂ disconnect battery with engine running or apply voltage to control units.
- If engine must be turned over but not started, remove and ground coil wire. A fast charger can be used as a starting aid for no more than 15 seconds at a time with a one minute break between attempts and a maximum of 16.5 volts.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.