Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fault Memory
Both FICU and ICU store faults for self-diagnosis. If a fault occurs, computer memory will store a code and corrective action will take place. For example, if coolant temperature sensor develops an open circuit, both control units will assume a calculation value of a fully warmed engine.
Fault will be displayed by a flashing of engine control indicator light. By inserting a fuse into top of fuel relay for 4 seconds, diagnostic terminals will be grounded and memories will be displayed by a flashing sequential code on instrument cluster.
If ignition system is operating in a fully retarded position because of engine knock or a problem has developed in knock sensor system, indicator light will flash while driving.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.