1988 Audi 5000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE

Temperature Sensor

Temperature sensor consists of 2 thermally variable resistors. One resistor signals temperature of coolant to ICU. The other resistor signals same information to FICU.

These signals are used to provide corrections to air fuel mixture, depending on coolant temperature. Both resistors have same resistance value. Temperature sensor is located in cylinder head coolant outlet flange.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.