Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Audi 5000 CS, StandardFACTORY OEM SERVICE PROCEDURE
Residual Pressure
- Connect Pressure Gauge (VW 1318 ) as previously described. See Figure . Open pressure gauge valve. Operate fuel pump for at least 30 seconds.
- Shut off fuel pump. Note system pressure. Pressure should be 51 psi (3.6 kg/cm2 ) after 10 minutes and 49 psi (3.4 kg/cm2 ) after 20 minutes.
NOTE:
The Residual Pressure Test does not include the cold start valve. To check cold start valve, reattach fuel line. Operate fuel pump. Visually check for leaks.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.