1987 Audi 5000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE

Idle Speed Control

Idle speed stabilizer is separate from digital control unit. The throttle switch is used to initiate idle speed control. Air control valve, located in throttle valve by-pass hose, receives signals from idle speed stabilizer.

With ignition on and engine off, air control valve is activated. This provides a valve opening which is determined by coolant temperature. After engine is started, idle stabilizer adjusts idle speed based on idle stabilizer thermo switch, throttle position, and engine RPM.

A/C operation will also send a signal to the ECU which will modify the signal to the air control valve. Engine speed is controlled by temperature from 1000 RPM at 0°F (-20°C) to low of 720 RPM at 68°F (20°C).

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.