1987 Audi 5000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE

Removal & Installation

NOTE: Removal and installation procedures pertain to the 5000S. Procedures for the Coupe GT are similar.

No procedures are available for removal and installation of CIS-E III related components. CIS-E III components are similar to those used in the CIS-E system. Refer to REMOVAL & INSTALLATION in BOSCH CIS-E SYSTEM article in this section.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.