Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Audi 5000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS LOCATION
| Component | Location |
|---|---|
| Auxiliary Relay Panel No. 1 | Under left side of dash. See Figure & Figure . |
| Auxiliary Relay Panel No. 2 | Under dash, behind stereo. See Figure & Figure . |
| Blower Motor Resistors | In left half of heater housing. |
| Diagnostic Trigger | On fuel pump relay. See Figure . |
| Oxygen Sensor Mileage Counter | Under left side of dash, against firewall. |
| Power Stage Module (Turbo) | To left of ignition coil. |
| Radiator Cooling Fan Resistor | Behind left headlight. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.