1987 Audi 5000 CS, AutomaticFACTORY OEM SERVICE PROCEDURE

"Anti-Lock" Light

If the anti-lock indicator light comes on while driving but the ABS system is still operating (evident by pulsating brake pedal during hard stops), check voltage supply at "D+" terminal on alternator and at terminal No. 15 of ABS control unit. All test values quoted refer to digital multimeter and ABS tester.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.