1986 Audi Coupe AutomaticFACTORY OEM SERVICE PROCEDURE

Airflow Sensor Plate: Notes

Basic Plate Lever Adjustment

NOTE: Always check basic sensor plate lever adjustment if fuel distributor or airflow sensor has been replaced.
  1. Check basic adjustment of sensor plate lever. With fuel distributor removed from airflow sensor housing, measure distance between roller on sensor plate lever and contact points of fuel distributor on top of airflow sensor housing.
  2. Use depth gauge or vernier caliper for measuring distance. See Fig 1 . Distance should be .74-.75" (18.9-19.1 mm). If distance is out of specified range, correct it with adjustment of mixture screw.
Fig 1: Basic Adjustment Of Sensor Plate Lever
G35387
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.