Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Glow Plugs
During cold starts, glow plugs are used to preheat swirl chambers. When current is applied, glow plugs become red hot. A temperature sensor connected to a time circuit in glow plug relay controls pre-heating time.
To start a cold engine on all models except 5000, pull out cold start knob to left of steering column. Turn ignition switch to glow plug position (No. 2). When light goes out, crank the engine. At below freezing temperatures, depress accelerator pedal while cranking. About 2 minutes after engine starts, push cold start knob in fully.
The cold starting device of 5000 is automatically controlled by engine coolant passing over a thermostat. When engine is cold, thermostat pulls on advance lever advancing injection timing.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
