Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Audi 5000 BaseFACTORY OEM SERVICE PROCEDURE
5000 Auto. Trans.
- Drive vehicle to warm up engine. Minimum oil temperature is 140° F (60° C). Turn off all electrical accessories including air conditioning. Apply hand and foot brake, engage transmission in "Drive". Ensure engine fan is not running.
- Perform stall test at end of warm up drive, do not turn engine off. Push accelerator to floor (kick down position), stall speed must be at least 2400 RPM within 4 to 7 seconds.CAUTION: Do not check stall speed longer than 10 seconds.
- If stall speed is not within specifications, full load screw on injector pump must be adjusted. While holding screw with wrench, not screwdriver, loosen lock nut and turn screw clockwise 1/8 turn maximum. Tighten lock nut and recheck stall speed.
- If stall speed is reached in less than 4 seconds, back off adjusting screw (counterclockwise) very slightly. Reseal screw with yellow paint.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.