Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1983 Audi 5000 BaseFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| Cruise Control Unit | Under left side of dash. See Figure . |
| Dynamic Oil Pressure Control Unit | Behind instrument cluster. |
| Idle Stabilizer Control Unit | Relay panel, lower right side. |
| Ignition Control Unit | Behind left kick panel. |
| Oxygen Sensor Control Unit | Under dash, right side of glove compartment. |
| Upshift Indicator Control Unit | On fuse/relay panel. |
| Water-In-Fuel Control Unit | Under left side of dash, near cruise control unit. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.