Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Audi 5000 Base, Automatic TransFACTORY OEM SERVICE PROCEDURE
BOSCH Hall Effect Electronic Ignition: Overhaul: Disassembly
NOTE:
The Hall Effect switch and trigger wheel (segmented shutter) cannot be removed on Saab models. If problem exists, entire distributor must be replaced.
- Loosen ground strap and remove static shield from distributor cap. See Figure. Remove cap, rotor, carbon brush and spring. Remove dust cover.
- Remove connector from distributor (connects Hall generator and harness leading to idle stabilizer). Remove retaining snap ring and trigger wheel (segmented shutter). Remove washers. Remove screws and lift out Hall sending unit and connecting socket.
- Remove base plate and vacuum unit. Remove pin and distributor drive pinion and shims.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.