Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Opening Pressure Test
With testing gauge (US 1111) still connected to injector, move pump lever down slowly. Note pressure at which injection nozzle releases fuel. Adjust, if necessary, by changing shims until working pressure reaches 2248-2364 psi (158-166 kg/cm2 ) for Turbo Diesel models or 1706-1850 psi (120-130 kg/cm2 ) for all other models. Thicker shims increase pressure, thinner shims decrease pressure.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
