1985 American Motors Encore BaseFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

ALIGNMENT SPECIFICATIONS

Application Specification
Caster (Degrees) (1) + 1/2 to + 2
Camber (Degrees) (1) F - 3/16 to + 5/16 Rr -1/2 +/- 1/2
Toe-in (Inches) F 0 Out 1/4 Rr 0 to - 1/2Β°
Toe-Out on Turns (Degrees)
Inner N/A
Outer N/A
(1) Non-adjustable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.