1985 American Motors Encore BaseFACTORY OEM SERVICE PROCEDURE

Ignition System - 1.4L: Overhaul

As the distributor has no reluctor, pick-up coil, nor centrifugal or vacuum advance, overhaul procedures are simple. Remove distributor cap and rotor. Remove pin from drive gear. Check shaft for burrs, and remove shaft from housing. Reassemble in reverse order.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.