Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1985 American Motors Encore BaseFACTORY OEM SERVICE PROCEDURE
Switch Test
- Connect a jumper wire between Red wire and Yellow or Violet wire at switch connector. Connect a second jumper between Black wire and Orange or Dark Green wire. Motor should move window up or down.
- Reverse jumper wire connections. Motor should move window in opposite direction from first test. See Figure . If motor operates properly, reconnect switch and test for correct operation. If not, replace switch. If motor did not operate properly, test window motor. Test all switches and motors.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
