Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal And Installation
Before removing and installing the clockspring and stalk unit the following preliminary operations must be carried out.
- Position the vehicle with the front wheels straight.
- Turn the ignition key to the Off position and extract it.
- Disconnect the battery cables and insulate them.
- Wait for 10 minutes before proceeding.
- FOLLOW ALL THE PRESCRIBED SAFETY INSTRUCTIONS. Refer to WARNINGΒ .
- Remove the trim from the steering column. Refer to SHROUD, STEERING COLUMN, REMOVAL AND INSTALLATION .
- Remove the Driver AirBag (DAB) from the steering wheel. Refer to AIR BAG, DRIVER, REMOVAL AND INSTALLATIONΒ .
- Remove the steering wheel from the upper steering column shaft. Refer to WHEEL, STEERING, REMOVAL AND INSTALLATION .
- Clockspring (1a) is equipped with a device that automatically stops it from rotating when it is removed from the steering column. If the stalk unit (1f) is reused, take care not to press the clockspring ring (1b) in order not to turn the upper ring nut (1c) with respect to the lower ring nut (1d) and affect the operation of the clockspring.NOTE:
In the event of reuse of the clockspring it is advisable to tie up the two wheels (1c) and (1d) by applying a band to retainers (1e).
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
