Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2017 Alfa Romeo 4C BaseFACTORY OEM SERVICE PROCEDURE
Module, Park Assist (PTS/PAM)
DIAGNOSTIC CODE INDEX
| DTC | Description |
|---|---|
| B1000-44 | ELECTRONIC CONTROL UNIT - DATA MEMORY FAILURE |
| B1000-45 | ELECTRONIC CONTROL UNIT - PROGRAM MEMORY FAILURE |
| B1000-46 | ELECTRONIC CONTROL UNIT - CALIBRATION/PARAMETER MEMORY FAILURE |
| B1000-47 | ELECTRONIC CONTROL UNIT - WATCHDOG/SAFETY C FAILURE |
| B1000-96 | ELECTRONIC CONTROL UNIT - COMPONENT INTERNAL FAILURE |
| C100B-12 | SENSOR REAR OUTER LEFT - CIRCUIT SHORT TO BATTERY |
| C100B-14 | SENSOR REAR OUTER LEFT - CIRCUIT SHORT TO GROUND OR OPEN |
| C100B-29 | SENSOR REAR OUTER LEFT - SIGNAL INVALID |
| C100C-12 | SENSOR REAR INTERNAL LEFT - CIRCUIT SHORT TO BATTERY |
| C100C-14 | SENSOR REAR INTERNAL LEFT - CIRCUIT SHORT TO GROUND OR OPEN |
| C100C-29 | SENSOR REAR INTERNAL LEFT - SIGNAL INVALID |
| C100D-12 | SENSOR REAR INTERNAL RIGHT - CIRCUIT SHORT TO BATTERY |
| C100D-14 | SENSOR REAR INTERNAL RIGHT - CIRCUIT SHORT TO GROUND OR OPEN |
| C100D-29 | SENSOR REAR INTERNAL RIGHT - SIGNAL INVALID |
| C100E-12 | SENSOR REAR OUTER RIGHT - CIRCUIT SHORT TO BATTERY |
| C100E-14 | SENSOR REAR OUTER RIGHT - CIRCUIT SHORT TO GROUND OR OPEN |
| C100E-29 | SENSOR REAR OUTER RIGHT - SIGNAL INVALID |
| C1017-1C | SENSOR POWER SUPPLY - CIRCUIT VOLTAGE OUT OF RANGE |
| U0019-87 | B CAN - MISSING MESSAGE |
| U0019-88 | B CAN - BUS OFF |
| U1700-86 | BODY COMPUTER MODULE - SIGNAL INVALID |
| U1700-87 | BODY COMPUTER MODULE - MISSING MESSAGE |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.