Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Alfa Romeo Spider GraduateFACTORY OEM SERVICE PROCEDURE
Fuel Pressure
CAUTION:
Constant fuel pressure is maintained in fuel lines and component parts at all times. Relieve pressure before attempting to open system for testing. Do not allow fuel to flow onto engine or electrical parts or allow an open flame in area while testing fuel system components.
- Release fuel system pressure. Remove fuel supply line at cold start injector and connect fuel pressure gauge. Disconnect vacuum hose from pressure regulator and connect hand vacuum pump to regulator. Turn ignition on and check pressure reading. See FUEL PRESSURE SPECIFICATIONS table.
- Apply 16 in. Hg to pressure regulator. Reading should drop about 7 psi (.5 kg/cm2 ). If pressure is too low, check fuel pump delivery rate. If pressure is too high, check fuel return line. If readings are still not as specified, replace regulator.
FUEL PRESSURE SPECIFICATIONS
| Application | psi (kg/cm2 ) |
|---|---|
| All Models | 33-39 (2.3-2.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.