Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Alfa Romeo Milano VerdeFACTORY OEM SERVICE PROCEDURE
EZL CEC System: Testing
COOLANT SENSOR RESISTANCE SPECIFICATIONS
| Coolant Temperature | Resistance |
|---|---|
| 32°F (0°C) | 5.8 Ohms |
| 50°F (10°C) | 3.8 Ohms |
| 68°F (20°C) | 2.5 Ohms |
| 86°F (30°C) | 1.7 Ohms |
| 104°F (40°C) | 1.1 Ohms |
| 176°F (80°C) | .33 Ohms |
- Ignition coolant temperature sensor is located in the thermostat housing. See Fig 1 . Using ohmmeter, check that contact to ground is closed with engine cold.
- Operate engine until coolant temperature is at least 95-106°F (35-41°C). Contact should open at this temperature. Replace unit if contact did not operate.TIMING ADVANCE SPECIFICATIONS
RPM Degrees BTDC 900 6-14 2000 12-20 2400 26-34 - Install tachometer and timing light. Disconnect ignition ECU connector. Disconnect vacuum advance hose. Raise engine to 3000 RPM. Note timing advance reading. Timing advance should be 12-16 degrees.
- Connect ignition ECU connector. Ground ignition coolant temperature sensor with jumper wire. Raise engine to 3000 RPM. Note timing advance reading. Timing advance should be 6-9 degrees. Replace ignition ECU if timing advance reading is not within specification.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
