Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Acura TLX BaseFACTORY OEM SERVICE PROCEDURE
Exploded View Legend
For Replacement of components listed below, see Repair ProcedureΒ
| *1: 2 types *2: With AWD |
| *1: 2 types *2: Without AWD |
Transmission Area Components
| Component Name | Callout |
|---|---|
| ATF Warmer Strainer | 1 |
| Sealing Bolt | 2 |
| Breather Box | 3 |
| Breather Tube | 4 |
| Transfer Breather Box | 5 |
| Alternator Harness Bracket | 6 |
| Countershaft Speed Sensor | 7 |
| Level Plug | 8 |
| Filler Plug | 9 |
| Transmission Control Module (TCM) | 10 |
| ATF Warmer | 11 |
| Water Bypass Hose | 12 |
| Drive Plate | 13 |
| Differential Oil Seal (Torque Converter Housing Side) | 14 |
| Drain Plug | 15 |
| Transmission Mount | 16 |
| Torque Converter Housing Cover | 17 |
| Differential Oil Seal (Transmission Housing Side) | 18 |
| Control Shaft Oil Seal | 19 |
| Transmission | 20 |
| Valve Body Assembly | 21 |
| Front Cover | 22 |
| Mainshaft Speed Sensor | 23 |
| Torque Converter Cover | 24 |
| Torque Converter | 25 |
| Torque Converter Oil Seal | 26 |
| 11 x 27 mm Pipe | 27 |
| 25.4 x 19 mm Pipe | 28 |
| 20.4 x 19 mm Pipe | 29 |
| Solenoid Wire Harness | 30 |
| ATF Temperature Sensor (Integrated with Solenoid Wire Harness) | 31 |
| Solenoid Wire Harness Connector | 32 |
| 11 x 24.5 mm Pipe | 33 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
