Keyless Access Control Unit DTCS

2018 Acura RLX BaseSECTION Keyless Access Control Unit DTCS
KEYLESS ACCESS CONTROL UNIT DIAGNOSTIC TROUBLE CODE (DTC) INDENTIFICATION

DTC Description DTC type
B1601 Keyless access control unit internal (CPU) error Internal error
B1602 Keyless access control unit internal (EEPROM) error Internal error
B1627 RF1 unit disconnected (2-way transceiver or RF antenna) Signal error
B1632 MTR CONT signal error Signal error
B1640 RF1 antenna not connected or malfunction Signal error
B1641 RF2 antenna not connected or malfunction Signal error
B1645 Driver's door LF antenna circuit short Signal error
B1646 Driver's door LF antenna circuit open Signal error
B1647 Passenger's door LF antenna circuit Short Signal error
B1648 Passenger's door LF antenna circuit open Signal error
B1649 Driver side rear passenger door LF antenna circuit short Signal error
B1650 Driver side rear passenger door LF antenna circuit open Signal error
B1651 Passenger side rear passenger door LF antenna circuit short Signal error
B1652 Passenger side rear passenger door LF antenna circuit open Signal error
B1657 Rear bumper LF antenna circuit short Signal error
B1658 Rear bumper LF antenna circuit open Signal error
B1659 Front interior LF antenna circuit short Signal error
B1660 Front interior LF antenna circuit open Signal error
B1663 Rear interior LF antenna circuit short Signal error
B1664 Rear interior LF antenna circuit open Signal error
B1667 Rear shelf LF antenna circuit short Signal error
B1668 Rear shelf LF antenna circuit open Signal error
U0199 Keyless access control unit - door multiplex control unit communication error Loss of communication
U1280 B-CAN communication bus line error (BUS-OFF) Loss of communication
U1281 Keyless access control unit lost communication with MICU Loss of communication
U128D Keyless access control unit lost communication with gauge control module Loss of communication
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.