Quick Lookups: Fluids

2018 Acura MDX BaseSECTION Fluids
FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Gas 4.00 OZS. 0.11 L ND-OIL8 S
Air Cond Refrigerant Gas N/A N/A HFC-134a (R-134a) Capacity is between: 1.50 - 1.60 lbs. S
Automatic Transmission Fluid Automatic Trans Drain and Refill 3.50 QTS. 3.31 L ACURA Automatic Transmission Fluid ATF-TYPE 3.1 or Higher S
Brake Fluid N/A N/A ACURA Heavy Duty DOT 3 Brake Fluid Use DOT 4 as a temporary replacement. S
Differential Gear Oil Gas Drain and Refill,Rear 1.92 QTS. 1.81 L ACURA DPSF-II S
Engine Coolant Gas 1.96 GALS. 7.41 L 50/50 mix of HONDA Long-Life Antifreeze/Coolant Type 2 and distilled water Change including the remaining 0.22 US gal (0.82 L) in the reserve tank). S
Engine Oil Gas Drain and Refill,w/Filter 5.70 QTS. 5.39 L Genuine ACURA Motor Oil API Premium-grade SAE 0W-20 Detergent Oil. You may also use synthetic motor oil if it is labeled with the API Certification Seal and is the specified viscosity grade. S
Engine Oil Gas Drain and Refill,w/o Filter 5.40 QTS. 5.11 L Genuine ACURA Motor Oil API Premium-grade SAE 0W-20 Detergent Oil. You may also use synthetic motor oil if it is labeled with the API Certification Seal and is the specified viscosity grade. S
Fuel Tank 19.50 GALS. 73.81 L S
Transfer Case Fluid Gas 0.45 QTS. 0.42 L ACURA HGO-1 Hypoid gear oil SAE 75W-85 or SAE 90 API-GL-4 or GL-5 S
Windshield Washer Fluid 4.00 QTS. 3.78 L Use commercially-available windshield washer fluid only. S
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.