DTC C0049-7B: Brake Fluid Level Too Low

2015 Acura RLXSECTION DTC C0049-7B: Brake Fluid Level Too Low
Confirmation Procedure Basic Condition:
  • 12 volt battery voltage 9.6 - 16.5 V

Operating Condition:

  1. 1.

    Turn the vehicle to the ON mode.

  2. 2.

    Wait for 60 seconds or more.

Execution Regular Diagnosis
Duration About 60 seconds
DTC Type
  • 1 drive cycle
  • Brake system indicator (amber) on
  • VSA indicator on
Fail Safe Action
  • Degrade ABS performance
  • Stop engine drag torque control function
  • Stop TCS function (Fade out)
  • Stop VSA function
  • Stop agile handling assist function
  • Stop brake assist function
  • Stop hill start assist function
  • Stop automatic brake hold function (Fade out)
  • Stop hydraulic brake booster function
  • Stop driving support system's brake function
Possible Cause
  • Short to ground between the gauge control module and the brake fluid level switch (BRAKE LEVEL SW line)
  • Low brake fluid level
  • Brake fluid level switch failure
  • Gauge control module internal failure
  • VSA modulator-control unit internal failure
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.