Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Compression Inspection (2016-18): Inspection
NOTE: After this inspection, you must reset the PCM. Otherwise, the PCM will continue to stop the injectors from operating.
- Engine - Warm Up
1. Start the engine. Hold the engine speed at 3, 000 rpm with no load (in P or N) until the radiator fan comes on, then let it idle. - HDS DLC - Connect
NOTE: For specific operations, refer to the user's manual that came with the HDS. Make sure the HDS is loaded with the latest software. 1. Press the engine start/stop button to select the OFF mode.
2. Connect the HDS to the DLC - Refer to: How to Troubleshoot the Fuel and Emissions Systems (2016-18), or How to Troubleshoot the A/T System (2016-18) .
3. Press the engine start/stop button to select the ON mode.
4. Make sure the HDS communicates with the vehicle. If it does not communicate, go to the DLC circuit troubleshooting .
- All INJECTOR STOP - Select
1. Select ALL INJECTORS STOP in the PGM-FI INSPECTION menu with the HDS 2. Press the engine start/stop button to select the OFF mode.
- Ignition Coil and Spark Plug - Remove
- Engine Compression - Inspect
1. Attach a compression gauge to the spark plug hole 2. Step on the accelerator pedal to open the throttle fully, then crank the engine with the starter motor, and measure the compression.
Compression Pressure: Above 930 kPa (9.48 kgf/cm 2 , 134.8 psi) 3. Measure the compression on the remaining cylinders.
Maximum Variation: Within 200 kPa (2.04 kgf/cm 2 , 29.0 psi) 4. If the compression is not within specifications, perform a cylinder leak down test to determine the problem area. Then check the following items, and remeasure the compression:
- Incorrect valve clearance
- Confirmation of camshaft timing
- Damaged or worn cam lobes
- Damaged or worn valves and seats
- Damaged cylinder head gasket
- Damaged or worn piston rings
- Damaged or worn piston and cylinder bore
5. Remove the compression gauge from the spark plug hole.
- Ignition Coil and Spark Plug - Install
- All INJECTOR STOP - Cancel
1. Select PCM reset - Refer to: How to Troubleshoot the Fuel and Emissions Systems (2016-18), or How to Troubleshoot the A/T System (2016-18) in the PGM-FI mode menu to cancel ALL INJECTORS STOP with the HDS.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.