Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Engine Control System / Engine Mechanical - Service Information (Except Hybrid)
2015 Acura MDX BaseSECTION Engine Control System / Engine Mechanical - Service Information (Except Hybrid)
- Removal Installation Test
- Removal and Installation
- A/F Sensor Removal and Installation
- Accelerator Pedal Module Removal and Installation
- Air Cleaner Removal and Installation
- CKP Sensor Removal and Installation
- CMP Sensor Removal and Installation
- Camshaft Pulley Removal and Installation
- Camshaft Removal and Installation
- Crankshaft Pulley Removal and Installation
- DC-DC Converter Removal and Installation (2016 2017 2018 2019 2020)
- Drive Plate Removal and Installation (2014 2015)
- Drive Plate Removal and Installation (2016 2017 2018 2019 2020)
- ECT Sensor 1 Removal and Installation
- ECT Sensor 2 Removal and Installation
- EGR Pipe Removal and Installation
- EGR Valve Removal and Installation
- EVAP Canister Purge Valve Removal and Installation
- EVAP Canister Removal and Installation
- EVAP Canister Vent Shut Valve Removal and Installation
- EVAP Two Way Valve Removal and Installation
- Engine Block Sealing Bolt Removal and Installation
- Engine Oil Pan Removal and Installation
- Engine Removal and Installation (2014 2015)
- Engine Removal and Installation (2016 2017 2018 2019 2020)
- FTP Sensor Removal and Installation
- Front Rocker Arm Oil Control Valve Removal and Installation
- Injector Control Module Removal and Installation
- Injector Removal and Installation
- Intake Air Resonator Removal and Installation
- Intake Manifold Removal and Installation
- Knock Sensor Removal and Installation
- MAF Sensor/IAT Sensor Removal and Installation
- MAP Sensor Removal and Installation
- PCM Removal and Installation (2014 2015)
- PCM Removal and Installation (2016 2017 2018 2019 2020)
- PCV Valve Removal and Installation
- Piston, Ring, Pin, and Connecting Rod Removal and Installation
- Rear Rocker Arm Oil Control Valve Removal and Installation
- Rocker Arm Assembly Removal and Installation
- Rocker Arm Oil Pressure Switch A (Bank 1) Removal and Installation
- Rocker Arm Oil Pressure Switch A (Bank 2) Removal and Installation
- Rocker Arm Oil Pressure Switch B (Bank 1) Removal and Installation
- Secondary HO2S Removal and Installation
- Throttle Body Removal and Installation
- Under-Floor TWC Removal and Installation
- Valve, Spring, and Valve Seal Removal and Installation
- Warm Up TWC Removal and Installation
- Water Passage Removal and Installation (2014 2015)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.