2014 Acura TL BaseFACTORY OEM SERVICE PROCEDURE

Spark Plug Inspection

  1. Remove the ignition coils and the spark plugs .
  2. Inspect the electrodes and the ceramic insulator.
    • Burned or worn electrodes may be caused by these conditions:
      • Advanced ignition timing
      • Loose spark plug
      • Plug heat range too hot
      • Insufficient cooling
    • Fouled plugs may be caused by these conditions:
      • Retarded ignition timing
      • Oil in combustion chamber
      • Incorrect spark plug gap
      • Plug heat range too cold
      • Excessive idling/low speed running
      • Clogged air cleaner element
      • Deteriorated ignition coils
    Fig 1: Identifying Spark Plug
    G08068580Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Replace the plug at the specified interval, or if the center electrode (A) is rounded, or if the spark plug gap (B) is out of specification, or if the spark plug electrode is dirty or contaminated. Use only the spark plugs listed.
    NOTE:
    • Do not adjust the gap of iridium tip plugs.
    • Do not use a plug cleaner.

    J35Z6 engine 

    Spark Plugs 

    NGK: DILZKR7A11G 

    Electrode Gap 

    Standard (New): 1.0- 1.1 mm (0.039- 0.043 in) 

    J37A4 engine 

    Spark Plugs 

    NGK: ILZKR7B-11S 

    DENSO: SXU22HCR11S 

    Electrode Gap 

    Standard (New): 1.0- 1.1 mm (0.039- 0.043 in) 

    J35Z6 engine 

    Fig 2: Identifying Electrode Gap In J35Z6 Engine
    G08068581Courtesy of AMERICAN HONDA MOTOR CO., INC.

    J37A4 engine 

    Fig 3: Identifying Electrode Gap In J37A4 Engine
    G08068582Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the spark plugs  and the ignition coils.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.