2013 Acura ZDXFACTORY OEM SERVICE PROCEDURE

Transfer Assembly Removal

  1. Raise the vehicle on a lift, and make sure it is supported securely.
  2. Shift the transmission into N.
  3. Remove the engine undercover.
    Fig 1: Locating Engine Undercover And Bolts
    G08075050Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the drain plug (A), and drain the automatic transmission fluid (ATF).
    Fig 2: Locating Drain Plug And Sealing Washer With Torque Specifications
    G08075051Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Reinstall the drain plug with a new sealing washer (B).
  6. Remove the front subframe stiffener.
    Fig 3: Identifying Front Subframe Stiffener And Bolts
    G08075052Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove exhaust pipe A (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
  8. Remove the bolt securing the transfer breather hose bracket (A), and disconnect the breather hose (B) from the breather pipe (C) on the transfer assembly.
    Fig 4: Identifying Transfer Breather Hose Bracket, Breather Hose And Breather Pipe
    G08075053Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. Make reference marks (A) across the No. 1 propeller shaft (B) and the transfer companion flange (C).
    Fig 5: Identifying No. 1 Propeller Shaft, Transfer Companion Flange And Reference Marks With Mounting Bolts
    G08075054Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Separate the No. 1 propeller shaft from the transfer companion flange.
  11. Remove the transfer assembly from the transmission.
    Fig 6: Identifying Transfer Assembly And Bolts
    G08075055Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.