2013 Acura ZDXFACTORY OEM SERVICE PROCEDURE

Transfer Assembly Installation

  1. Clean the areas where the transfer assembly contacts the transmission with solvent, and dry with compressed air. Then apply ATF to the contact area.
  2. Install the dowel pin (A) in the transmission, and install the transfer assembly (B) on the transmission.
    Fig 1: Transfer Assembly And Dowel Pin With Mounting Bolts With Torque Specifications
    G08075056Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the No. 1 propeller shaft (A) to the transfer companion flange (B) by aligning the reference marks (C). Make sure you use new mounting bolts.
    Fig 2: No. 1 Propeller Shaft, Transfer Companion Flange And Reference Marks With Mounting Bolts With Torque Specifications
    G08075057Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the transfer breather hose bracket (A) on the transfer assembly, and connect the breather hose (B) over the breather pipe (C) with facing the dot mark (D) to the rear side of the vehicle.
    Fig 3: Transfer Breather Hose Bracket, Breather Hose And Breather Pipe With Torque Specifications
    G08075058Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install exhaust pipe A (see EXHAUST PIPE AND MUFFLER REPLACEMENT ).
  6. Install the front subframe stiffener with new mounting bolts.
    Fig 4: Front Subframe Stiffener With Mounting Bolts With Torque Specifications
    G08075059Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Refill the transfer assembly with transfer fluid (hypoid gear oil), if necessary (see TRANSFER ASSEMBLY FLUID REPLACEMENTΒ  ).
  8. Refill the transmission with ATF (see ATF REPLACEMENTΒ  ).
  9. Install the engine undercover.
    Fig 5: Engine Undercover With Mounting Bolts With Torque Specifications
    G08075060Courtesy of AMERICAN HONDA MOTOR CO., INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.