2013 Acura ZDXFACTORY OEM SERVICE PROCEDURE

FTP Sensor Replacement

  1. Raise the vehicle on a lift.
  2. Remove the EVAP canister cover (see step Β 2 ).
  3. Disconnect the FTP sensor 3P connector (A).
    Fig 1: Identifying FTP Sensor 3P Connector, Hose, O-Ring And Retainer
    G08075718Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Disconnect the hose (B), and remove the FTP sensor (C).
  5. Install the parts in the reverse order of removal with a new O-ring (D) and a new retainer (E).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.