2013 Acura ZDXFACTORY OEM SERVICE PROCEDURE

CMP Sensor Replacement

  1. Remove the timing belt (see TINNING BELT REMOVAL ).
  2. Remove the front camshaft pulley (CMP sensor pulse plate) (A).
    Fig 1: CMP Sensor Connector, Back Cover And Front Camshaft Pulley With Torque Specifications (CMP Sensor Pulse Plate)
    G08075665Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Disconnect the CMP sensor connector (B), then remove the back cover (C).
  4. Remove the CMP sensor (A) from the back cover.
    Fig 2: CMP Sensor With Mounting Bolt With Torque Specifications
    G08075666Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the parts in the reverse order of removal, then reinstall the timing belt (see TIMING BELT INSTALLATION ).
  6. Do the CKP pattern clear/CKP pattern learn procedure (see CKP PATTERN CLEAR/CKP PATTERN LEARN ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.