SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSACURA2013TL SH-AWD, AUTOMATIC TRANSREPAIR AND DIAGNOSISBODY & FRAMESEATSDRIVER POSITION MEMORY SYSTEMDRIVING POSITION MEMORY SWITCH TEST/REPLACEMENT
2013 Acura TL SH-AWD, Automatic Trans

Driving Position Memory Switch Test/Replacement

2013 Acura TL SH-AWD, Automatic TransSECTION Driving Position Memory Switch Test/Replacement
  1. Remove the driver's door panel (see FRONT DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 7P connector (A) from the driver's position memory switch (B).
    Fig 1: Identifying 7P Connector And Driver'S Position Memory Switch
    G08067612Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two screws, then remove the switch from the door panel.
  4. Check for continuity between the terminals in each switch position according to the table.
    NOTE:
    • Make sure the correct test lead (+ or -) is placed on the terminal.
    • When checking for continuity across the diode, use the diode setting on the digital volt/ohm meter to check the diode bias.
    • Be careful of this characteristic; a diode is one that conducts fully in one direction (forward) and not at all in the opposite direction (reverse).
      Fig 2: Checking Continuity Between Terminals In Each Switch Position According To Table
      G08067613Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the switch.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.