2012 Acura ZDXFACTORY OEM SERVICE PROCEDURE

Specifications Index

ZDX SPECIFICATIONS INDEX

System Specification/Procedure
Air Conditioning
Service AIR CONDITIONING
Torque HVAC SERVICE SPECIFICATIONS - ZDX
Axle Nut/Hub Nut
Front 329 N.m (242 ft. lbs.)
Rear 245 N.m (181 ft. lbs.)
Battery BATTERY
Brakes
Bleeding Sequence BRAKE SYSTEM BLEEDING
Disc Brakes BRAKES
Torque BRAKES
Charging
Generator ENGINE ELECTRICAL
Torque ENGINE ELECTRICAL
Drive Belts
Adjustment DRIVE BELT INSPECTION
Belt Routing COMPONENT LOCATION INDEX & DRIVE BELT ROUTING & DRIVE BELT REPLACEMENT
Engine Cooling
General Service Specifications COOLING SYSTEM
Radiator Cap Pressure 93-123 kPa (0.95-1.25 kgf/cm2 , 14-18 psi)
Thermostat R & I THERMOSTAT REPLACEMENT
Water Pump R & I WATER PUMP REPLACEMENT
Engine Mechanical
Compression ENGINE ASSEMBLY
Oil Pressure (176Β°F (80Β°C) 70 kPa (.7 kgf/cm2 , 10 psi) @ idle; 490 kPa (5.00 kgf/cm2 , 71.1 psi) min. @ 3000 RPM
Overhaul See applicable specifications table in ENGINE SERVICE SPECIFICATIONS - ZDX .
Torque ENGINE SERVICE SPECIFICATIONS - ZDX
Fluid Specifications See FLUIDS under MAINTENANCE tab.
Flywheel/Flex Plate (Drive Plate) Torque
A/T 74 N.m (54 ft. lbs.)
Fuel System
Pressure Specification 380-430 kPa (3.9-4.4 kgf/cm2 , 55-63 psi)
Fuel Pressure Test Procedure FUEL PRESSURE TEST
Fuel Filter Location FUEL FILTER REPLACEMENT
Ignition
Firing Order & Cylinder Identification FIRING ORDER & CYLINDER IDENTIFICATION
Spark Plug (NGK: ILZKR7B-11S; DENSO: SXU22HCR-11S)
Gap 1.0-1.1 mm (.039-.043 in.)
Torque 18 N.m (13 ft. lbs.)
Starting
Starter ENGINE ELECTRICAL
Torque STARTER REMOVAL AND INSTALLATION
Wheel Alignment
Adjustment Specifications SUSPENSION
Torque
Front SUSPENSION
Rear SUSPENSION
Wheel & Tire
Wheel Lug Nut Torque 127 N.m (94 ft. lbs.)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.